Canon DR-6080 Manual do Proprietário

SCANNING BASICSUSEFUL FEATURESTROUBLESHOOTINGQUICK REFERENCEDOCUMENT SCANNER

9USERPREFERENCESTo promote ease of use, the bundled ISIS/TWAIN driver offersregistration of up to 100 sets of customized scan settings. Afterregistrat

102SKIP BLANK PAGEUseful for scanning batches that include single- and double-sideddocuments, this featureautomatically removesblank pages from theima

113STEP 1Remove documents from the scanner’s upper and lower trays, andremove any extra parts attached to the upper tray. Close thedocument eject tray

123STEP 1Remove documents from the scanner’s upper and lower trays, andremove any extra parts attached to the upper tray. Close thedocument eject tray

133ERROR CODESTROUBLESHOOTINGError codes appear on the operation panel’s counter display when ascanner malfunction occurs. Error Code Cause and Soluti

143A complete list of error codes and solutions to other types ofscanner trouble can be found in Chapter 6 of the Instructionsmanual (“Troubleshooting

CANON Customer Service Centers© CANON ELECTRONICS INC. 2003 PRINTED IN JAPANPUB.CE-CE-305 0104AB0.2*CE-CE-305*

PRECAUTIONS1● Make sure that your documents are within the acceptable scanning sizes. Width: 2.2 – 12 inches (55 – 305 mm)Length: 2.8 – 17 inches (70

SCANNING BASICSGETTING STARTEDThis section explains the basic steps involved in scanning adocument. It assumes that the batch to be scanned contains p

3SCANNING BASICSSTEP 2▲1 Long DocumentsIf the document you are scanning is long, open the document ejecttray extension. Next, lift up the stopper and

STEP 3The DR-6080 and the DR-9080C are operated via the bundledISIS/TWAIN driver, which is compatible with a wide range ofapplication software. Use th

5STEP 4Prepare your documents by aligning the batch so that its edges areeven. Then place the batch on the document tray with the documentsface up. Th

6SCANNING BASICS1STEP 4Place the first page of the batch face up in the document tray. Adjustthe document guides to the width of the page.▲STEP 5Use y

71STEP 4Place one page face up on the document tray. Adjust the documentguides to the width of the page. STEP 5Select Manual Feeding inFeeding Option

COUNT ONLYMODEIn this mode, documents are fed through the scanner and counted,not scanned. To use this mode, press the Count Only key on theoperation