Canon VB-M40B Manual do Utilizador descarregar pdf (Página 51)

[Network] Setting Administrator Password, LAN, IP Address, DNS, etc

5-7

Setting Page

SNMP

(1) [SNMP]

Set SNMP use to [Disable] or [Enable]. Camera

information can be referenced by the SNMP Manager

if [Enable] is specified.

(2) [Community Name]

Set a community name for SNMP. It is recommended

that you change the community name to ensure

system security.

(3) [Administrator Contact Information]

Set contact information (e-mail address, etc.) for the

Administrator of the camera. Setting information can

be referenced by the SNMP manager.

(4) [Administration Function Name]

Set the camera name used for administration. Setting

information can be referenced by the SNMP manager.

If left blank, the following will be used by default:

VB-M700

VB-M600

VB-M40

(5) [Installation Location]

Set information regarding the installation location of

this camera. Setting information can be referenced by

the SNMP manager.

Note

• The information set in the camera is read-only from the SNMP

manager.

• Use the SNMP Manager that supports SNMP MIB2 (supporting

RFC1213).

• Supports SNMP protocol versions v1 and v2c (v3

unsupported).

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 158 159

Sem comentários

Canon VB-M40B Manual do Utilizador Página 51