Canon Powershot SD430 Guia de Configuração descarregar pdf (Página 11)

The Camera Wireless Setup utility, as shown to

the right, will start up. Set the wireless settings in

this window.

7 Click [Next].

8 Select [Simple Mode] and click [Next].

We recommend you use the Simple Mode for

most purposes.

• We recommend you use the [Advanced Mode] if the following

conditions apply to your computer's wireless configuration.

• You are configuring an ad hoc network.

• You are performing the settings within a network with a system

administrator.

• The computer and wireless LAN router are connected by a cable.

• A fixed IP address is assigned. (IP address: an identifying number

assigned to a computer or other device on a network)

• Wireless LAN router is not equipped with a DHCP server function.

(DHCP server function: short for dynamic host configuration protocol

server function, which assigns dynamic IP addresses to devices in a

network)

• You can change the registered information in the camera if you place a

check mark beside [Change registered information in camera] and click

[Next].

If you are already using a wireless network, please proceed to Step 9 in the Wireless

Network Already In Use section (p. 12).

If you are using a 1:1 direct connection between the camera and computer, skip to

Step 9 in the 1:1 Direct Connection between Camera and Computer section (p. 14).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

Sem comentários

Canon Powershot SD430 Guia de Configuração Página 11