Canon imagePROGRAF W2200S Manual do Utilizador descarregar pdf (Página 24)

TCP/IP Network Settings (Windows)

2-8

Note

Important

Press  or  to select “Ethernet II” then press .

Press  or  to select “IP Mode” then press .

Select the method for setting the printer IP address. Press  or  to

select either setting below then press .

Automatic:

Select when the IP address is to be set with DHCP, BOOTP, or RARP.

Manual:

Select when the IP address is to be assigned directly for the printer.

If “Automatic” was selected at Step 6, press  or  to select

“Protocol”, press , then select ON or OFF for DHCP, BOOTP, and

RARP.

If “Manual” was selected at Step 6, press  or  to select “IP

Setting”, press , then select “IP Address”, “Subnet Mask”, or

“Default G/W”.

z Use the following method to select “IP Address”, “Subnet Mask”, or “Default G/

W”:

1. Press  or  to select the target field then press .

2. Press  or  to select the desired number then press .

3. Repeat Step 1 and 2 for all fields.

Press  3 times, press  or  to select Regis. Settings, then press

.

z In order to save the settings done in Step 4 to Step 7, you must execute “Regis.

Settings”. The selected settings will not be enabled unless they are registered with

“Regis. Settings”.

When you see “Execute?” in the operation panel display, press .

When you see “Registered!” in the operation panel display, press the

Online button. The Online lamp lights.

The printer is ready to print.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 106 107

Sem comentários

Canon imagePROGRAF W2200S Manual do Utilizador Página 24